Size the cleat to the line
The common rule of thumb is about 1 inch of cleat length for every 1/16 inch of line diameter. So 1/2-inch dock line wants a cleat around 8 inches long. When in doubt, go bigger: an oversized cleat holds a small line fine, but a small cleat won't hold enough turns of a big one.
| Cleat length | Line diameter (rule of thumb) |
|---|---|
| 4" | 1/4" |
| 6" | 3/8" |
| 8" | 1/2" |
| 10" | 5/8" |
| 12" | 3/4" |
| 15" | 15/16" |
| 16" | 1" |
Many manufacturers publish a larger maximum line size than the rule suggests. Where they do, the database shows their number. Where they don't, it shows the rule-of-thumb estimate marked with a ~.
For boat length, a rough starting point is about 1 inch of cleat for every foot of boat length up to 20 feet, then add a size for heavier or taller boats that catch more wind.
Pick a material for your water
| Stainless steel | Strongest and best-looking; 316 grade handles salt water. Costs the most. |
|---|---|
| Aluminum | Light, rustproof and the usual choice for docks. Softer than steel, so size up for heavy boats. |
| Galvanized iron or steel | Cheap and very strong. The zinc coating wears over the years, especially in salt water. |
| Nylon | Inexpensive and won't corrode or scratch. Best for small boats, kayaks and light duty. |
Mount it through something solid
Through-bolt cleats with a backing plate or large washers whenever you can. Lag screws into a single board pull out under shock loads. Use every hole the cleat has, and match the fastener size the manufacturer lists; you'll find it on each cleat's page.
Cleat types
The classic horn cleat on two feet with a gap between them, so you can pass a line through the middle as well as around the horns.
See 30 open base cleatsA horn cleat on a solid base. Simpler and often cheaper; lines go around the horns only.
See 3 closed base cleatsA solid-looking base with a hollow underside that saves weight. Common on stainless boat cleats.
See 6 hollow base cleatsA closed base that drains through a fitting underneath, so water can't sit inside the deck.
See 4 sealed base cleatsA short, flat horn on hidden threaded studs. Sits close to the deck so it snags less.
See 8 low-profile cleatsHinged on a base plate. It folds flat when you're not tied up, so nobody trips over it.
See 3 flip-up cleatsAnother name for flip-up: a hinged cleat that lies flat when not in use.
See 7 folding cleatsSits flush in a cut-out and pops up when pressed. Clean decks, no toe stubbing.
See 5 pop-up cleatsRecessed flush with the deck; you pull it up to use it and push it back down after.
See 9 pull-up cleatsA sweeping S-shaped horn. A popular look on aluminum docks; ties off quickly.
See 2 s cleat cleatsBuilt to sit on a dock edge or rail at an angle, so the line leads cleanly to the boat.
See the angled rail cleatMade to be welded to aluminum docks and gangways instead of bolted.
See 5 weld-down cleatsLarge, heavy commercial cleats for marinas, piers and bigger vessels.
See 2 mooring cleatsA cleat with a built-in light (often solar) that marks the dock edge at night.
See the lighted cleatSpring-loaded so it pulls back into a housing when the line comes off.
See the retractable cleatDrops into a rod holder or socket to add a cleat where there isn't one.
See the portable cleat