A horn cleat looks simple, but every part of its shape does a job. Knowing the parts makes it much easier to read a spec sheet and compare cleats in the database.
The parts
| Horns | The two arms the line wraps around. Smooth, rounded horns are easier on lines; rough castings chafe them. |
|---|---|
| Waist | The middle of the cleat between the horns, where the line crosses in a figure eight. |
| Base | The part that sits on the dock or deck. Open, closed, hollow and sealed bases all describe what's going on underneath. |
| Feet | On an open-base cleat, the two supports with a gap between them. You can pass a line or a spliced eye through the gap. |
| Clearance | The space under the horns. More clearance means room for more turns of a thicker line. |
| Bolt holes | Usually two or four. More holes and wider spacing spread the load into the dock or deck. |
Reading a spec sheet
- Length: horn tip to horn tip. This is the number in a cleat's name (an "8-inch cleat"). Some makers list a nominal size and a slightly longer actual length; the database notes both where they're published.
- Height: from the mounting surface to the top of the horns.
- Hole spacing: center to center, sometimes given both lengthwise and across. Match this when replacing an old cleat.
- Fastener size: the bolt diameter the holes take, such as 1/4" or 5/16". Each cleat's page lists it where available.
- Max line size: the largest line the maker says fits. If it isn't published, the database shows a rule-of-thumb estimate marked with ~.
Base styles
Open base
Closed base
Hollow base
Sealed base
More shapes, including flip-up, pull-up and S cleats, are in the sizing guide. Ready to choose one? Try the cleat size calculator.
Next guide: How to tie up when there's no cleat
