Sooner or later you'll pull up to a dock with no cleat in reach. Maybe it's a piling, an iron ring, a bollard or just a post. The three knots below handle nearly every case.
Round turn and two half hitches
Best for: rings, rails and posts. This is the most useful all-around tie-up knot.
- Pass the line around the ring or post twice. That's the round turn, and it takes the load while you tie.
- Bring the end around the standing part of the line and back through itself: one half hitch.
- Repeat in the same direction for a second half hitch, then pull snug.
It holds well under steady load and is easy to untie, even after a day of tugging.
Clove hitch
Best for: pilings and posts, for a quick, adjustable tie-off.
- Wrap the line around the piling.
- Cross over the first wrap and go around again.
- Tuck the end under the second wrap and pull tight.
Bowline
Best for: making a fixed loop to drop over a piling or bollard.
Tie a bowline in the end of your line to make a loop that won't slip or tighten, then drop it over the top of the piling or bollard. Many boaters keep one dock line with a spliced eye (a permanent loop) for exactly this.
Tips for pilings
- Tide: on fixed pilings, leave enough slack for the water to rise and fall, or the line will lift the boat or go slack. See tide, wind and current.
- Chafe: pilings are rough. Use a chafe guard where the line wraps.
- Low on the piling: a loop dropped over the top can ride up and pop off at high tide. Tie lower with a round turn and two half hitches if the piling is short.
Back on a cleat
When there is a cleat, use a cleat hitch. It's faster to tie and release than any of these.
Next guide: Marina and dock etiquette: the unwritten rules
