Guides

Tying up in tide, wind and current

Calm water forgives a sloppy tie-up. Tide, wind and current don't. Here's how to set lines for each.

The goal is the same in every condition: keep the boat off the dock, stop it from surging back and forth, and let it move just enough that nothing gets jerked hard. What changes is how much slack the lines need and where they lead.

Tide

On a floating dock, tide barely matters, because the dock rises with the boat. On a fixed dock, the boat rises and falls relative to the dock, and short lines will either hang the boat at low tide or go slack at high tide.

  • Use longer lines led to cleats farther away. A long line at a shallow angle changes length very little as the boat rises and falls; a short line straight across changes a lot.
  • Lean on spring lines. Long springs keep the boat in position fore and aft while still allowing vertical movement.
  • Cross the stern lines. Run the port stern line to the starboard-side cleat and vice versa. The longer crossed lines absorb tide better than straight ones.
  • Set lines at mid-tide, then check them at high and low water until you know they work.

Wind

  • Wind pushing you onto the dock: put out plenty of fenders and set the springs so the boat can't slide along the dock and catch a fender on a piling.
  • Wind pushing you off the dock: the lines carry the full load. Tighten them a little and add a second line at the bow and stern if a blow is coming.
  • Before a storm: double up every line, add chafe protection, and make sure each cleat is through-bolted with a backing block. Cleats are often the first thing to fail in a big blow.

Current

Current pushes the boat steadily in one direction. Put your strongest lines on the up-current end, usually a bow or spring line led well ahead, and size those cleats generously, because they carry the load around the clock.

Quick checklist

  • Bow, stern and two spring lines, at least
  • Lines long enough for the tidal range on fixed docks
  • Fenders at the widest point of the boat and near pilings
  • Chafe guards where lines cross edges
  • Cleats sized for the line and mounted solidly

Planning cleat positions? See how many cleats a slip needs.

Heavy-duty cleats for exposed slips

Next guide: Cleat backing plates: when you need one and how to fit it