Guides

Cleat backing plates: when you need one and how to fit it

The cleat holds the line. The backing plate holds the cleat. Skip it and the strongest cleat in the world can rip out.

When a line snaps tight, all of that force goes into the cleat's bolts and then into whatever the bolts pass through. Without backing, it's concentrated on a few small washers. With a backing plate, it's spread across a much bigger area of wood or fiberglass, so the bolts can't pull through.

When you need one

  • Boat decks and gunwales: almost always. Fiberglass and cored decks crush and crack under point loads.
  • Wooden docks: yes, as a backing block under the decking. It's the difference between a cleat held by one plank and a cleat held by the dock's frame.
  • Aluminum docks: follow the dock maker's mounting kit. Many use a plate or channel designed for their frame.

Many pop-up and pull-up cleats come with their own backing plate that doubles as the cut-out template.

Materials

Stainless steelThin, very strong and the usual match for stainless cleats on boats.
AluminumLight and strong; pair it with aluminum cleats to avoid mixing metals.
G-10 or fiberglass sheetWon't corrode or cause galvanic problems. Popular on boats.
Pressure-treated lumber or marine plywoodThe standard backing block for wooden docks. Run it across the joists.

How big

Make the plate noticeably larger than the cleat's base, so the load spreads well beyond the bolt holes. As a starting point, a plate about twice the cleat's base area is common on boats. On docks, a backing block long enough to reach between joists is the goal.

How to fit one

  1. Hold the cleat in place, mark the holes, and drill through the deck or decking.
  2. Use the cleat or a template to drill matching holes in the backing plate.
  3. On cored boat decks, seal the core around each hole first (many owners over-drill, fill with epoxy, and re-drill) so water can't soak in.
  4. Bed the cleat and bolts in marine sealant, fit the backing plate underneath, then add washers and lock nuts.
  5. Tighten evenly until snug. Check again after a few days and at the start of each season.
If you can't reach the underside, you can't fit a backing plate, and lag screws or self-tappers alone aren't a substitute. Look for another spot, or a cleat with a mounting system made for that surface.

Related: how to install a dock cleat and how to add cleats to a boat.

Cleats that ship with a backing plate

Next guide: How to replace a loose or rusted dock cleat