Most cleat failures aren't the cleat breaking. It's the fasteners pulling out of the wood. A gust or a passing wake hits the boat, the line snaps tight, and a couple of lag screws in one deck board let go. Here's how to install a cleat so that doesn't happen.
What you'll need
- The cleat, sized for your line (see the sizing guide)
- Bolts that match the cleat's holes, long enough to pass through the decking and backing block. Each cleat's page lists the fastener size.
- Large washers and nylon-insert lock nuts, in the same metal as the bolts
- A backing block (pressure-treated 2x6 or 2x8, or a metal backing plate)
- Drill, bits, wrench, and a marine sealant
1. Pick the spot
Place the cleat where the line will lead cleanly to the boat's cleat without crossing the dock edge at a sharp angle or rubbing on a piling. Keep it a few inches back from the edge so the base sits fully on solid wood. If you can, position it so the backing block can span between two joists.
2. Angle it to the load
Turn the cleat so it sits roughly 10 to 15 degrees off the direction the line will pull. That lets the line reach the far horn first when you tie a cleat hitch, so it won't jam on itself.
3. Drill and through-bolt
Mark the holes through the cleat, drill straight down, and run bolts through the decking and the backing block underneath. Use every hole the cleat has. Add washers under the nuts and tighten until snug, without crushing the wood.
4. Back it up
The backing block is what turns a cleat into a strong point. Run it across the underside of the decking, ideally reaching from joist to joist, so a hard pull is shared by the framing instead of one plank. On metal or composite docks, use the backing plate or mounting kit the manufacturer recommends.
5. Seal the holes
Bed the bolts in marine sealant so water can't wick into the holes and rot the wood around them. Wipe off the squeeze-out.
6. Check it each season
Wood shrinks and swells, and nuts loosen. Give each cleat a hard tug and re-tighten at the start of every season. Replace any cleat with cracked castings or bolts that have rusted thin.
Common mistakes
- Mounting to one deck board with lag screws
- Using fewer bolts than the cleat has holes
- Mixing stainless bolts with an aluminum or galvanized cleat in salt water without isolation (why that matters)
- Placing the cleat where the line saws across the dock edge
Cleats that through-bolt easily
Open-base and closed-base dock cleats with four holes or a wide base spread the load well.
- Attwood Fold-Down Dock Cleat 8in8" · ~1/2" line · Aluminum
- Dock Edge Flip-Up Dock Cleat 8in Polished8" · ~1/2" line · Almag 35 aluminum
- Gen3 Marine Stainless Folding Dock Cleat 8in8" · ~1/2" line · Steel
- K & R Dock Products Galvanized Cleat 8in8" · ~1/2" line · Steel
- Whitecap Galvanized Steel Dock Cleat 8in8" · ~1/2" line · Steel
- CIPA Cleat Seat Retractable Dock Cleat10" · ~5/8" line · Material not listed
Next guide: How many cleats does a boat slip need, and where do they go?
