A boat in a slip is usually held by four kinds of lines: a bow line, a stern line, and two spring lines that stop the boat surging forward and back. Each line wants its own cleat, placed so the line leads cleanly to the boat. Here's a layout that works for most recreational slips.
The basic layout
- Bow: one or two cleats at the end the bow points toward (the head of the slip if you pull in bow first), so the bow line leads forward and slightly out.
- Stern: one cleat on the finger a little behind the boat's stern, so the stern line leads aft.
- Spring lines: two cleats near the middle of the boat. One spring runs from the boat's midship cleat aft to the dock, and the other runs forward. They're what keep the boat from banging the dock end when wakes roll through.
- Both sides: if your slip has a finger on each side, mirror the layout so you can tie off either side or both in a blow.
Spacing by boat length
| Boat length | Cleats per side | Rough spacing |
|---|---|---|
| Under 20 ft | 3 (bow, midship, stern) | Spread along the boat's length |
| 20 to 30 ft | 4 | Bow, two midship, stern |
| 30 ft and up | 4 to 6 | Add extra midship cleats for longer springs |
These are starting points, not rules. Let the boat's own cleats guide you: put dock cleats where lines from the boat's bow, midship and stern cleats will lead at a comfortable angle.
Floating vs. fixed docks
On a floating dock, the dock rises and falls with the boat, so lines can be fairly short and cleats can sit close to the boat's cleats. On a fixed dock in tidal water, the boat moves up and down relative to the dock. Lines need to be longer, spring lines matter more, and cleats placed farther from the boat give the lines enough length to absorb the tide. There's more on this in cleats for floating vs. fixed docks.
Size every cleat for the line
Spring and bow lines carry the most load in a blow, so don't skimp on those cleats. Use the sizing guide to match cleat length to line diameter, and through-bolt them with a backing block.
- CIPA Cleat Seat Retractable Dock Cleat10" · ~5/8" line · Material not listed
- Dock Edge Dock Builders Angled Rail Cleat 10in10" · ~5/8" line · Aluminum
- Pacific Marine & Industrial Aluminum Dock Cleat 10in10" · ~5/8" line · Aluminum
- Sea-Dog Galvanized Dock Cleat 10in10" · ~5/8" line · Iron
- Whitecap Galvanized Steel Dock Cleat 10in10" · ~5/8" line · Steel
- JIF Marine Aluminum S Dock Cleat 12in12" · ~3/4" line · Aluminum
Next guide: Best dock cleats for floating docks vs. fixed docks
