Cleats on floating docks and fixed docks do the same job, but under different conditions. Here's what changes and what to look for on each.
Floating docks
A floating dock rises and falls with the water, so the boat stays at roughly the same height relative to the dock. Lines stay short and the pull on each cleat is mostly sideways and steady.
- Material: aluminum is the usual pick. It's light, rustproof, and matches aluminum dock frames. Nylon works on small-boat and kayak floats.
- Mounting: follow the dock maker's system. Aluminum frames take bolt-through or weld-down cleats; plastic modular docks use their own cleat kits.
- Low profile helps: floating docks get a lot of foot traffic, so flip-up cleats are popular.
- Size: match the line as usual, but because loads are steady you rarely need to oversize.
- Dock Edge Classic Cleat 6-1/2in Polished6-1/2" · ~3/8" line · Aluminum
- Attwood Fold-Down Dock Cleat 8in8" · ~1/2" line · Aluminum
- Pacific Marine & Industrial Aluminum Dock Cleat 8in8" · ~1/2" line · Aluminum
- JIF Marine Aluminum S Dock Cleat 12in12" · ~3/4" line · Aluminum
- Pacific Marine & Industrial Aluminum Dock Cleat 8in8" · ~1/2" line · Aluminum
- Pacific Marine & Industrial Aluminum Dock Cleat 10in10" · ~5/8" line · Aluminum
- Pacific Marine & Industrial Aluminum Dock Cleat 12in12" · ~3/4" line · Aluminum
Fixed docks
A fixed dock stays put while the boat rises and falls. In tidal water that means lines go slack at high tide and tight at low tide unless they're long enough and well placed. Cleats see sharper, more upward pulls and more shock load from wakes.
- Material: galvanized and stainless handle the higher loads well. Heavy-duty aluminum works if sized up.
- Size up: go one size larger than the line alone would suggest, since lines are longer and loads are peakier.
- Mounting: through-bolt with a backing block spanning the joists. This matters more on a fixed dock than anywhere else. See how to install a dock cleat.
- Placement: put cleats farther from the boat so long lines can absorb tide, and add pilings or extra cleats for spring lines.
- Sea-Dog Heavy Duty Open Base Cleat 10in10" · ~5/8" line · 316 stainless steel
- Whitecap Stainless Heavy Duty Hollow Base Cleat 10in10" · ~5/8" line · 316 stainless steel
- Sea-Dog Heavy Duty Open Base Cleat 12in12" · ~3/4" line · 316 stainless steel
Side by side
| Floating dock | Fixed dock | |
|---|---|---|
| Typical material | Aluminum, nylon | Galvanized, stainless |
| Sizing | Match the line | One size up |
| Line length | Short | Long, for tide |
| Popular types | Flip-up, open base, weld-down | Open base, heavy-duty |
Planning a whole slip? See how many cleats a slip needs.
Next guide: Dock line basics: size, length and type
