Guides

How to tie a cleat hitch (with diagrams)

Four moves, about ten seconds, and a hitch that holds in wind and current but still comes off with one pull.

The cleat hitch is the standard way to tie a dock line to a horn cleat. Done right, it holds under heavy load, doesn't jam, and can be released quickly even when the line is tight. Done wrong, it either slips or locks up so hard you need a knife.

The four steps

1. Go around the base. Lead the line to the horn farthest from the load, then take one full turn around the base of the cleat.
2. Cross over the top. Bring the line diagonally across the top and pass it under the opposite horn.
3. Cross back. Come back over the top on the other diagonal and around the first horn. You've made a figure eight.
4. Lock it. Make an underhand loop, flip it over the horn, and pull snug. The tail should lie parallel to the diagonal beside it.

Common mistakes

  • Starting on the near horn. If the line wraps the horn closest to the load first, it pinches against itself and can jam. Always go to the far horn first.
  • Skipping the turn around the base. That first full turn takes most of the load. Without it, the figure eight carries all the strain and the hitch is hard to release.
  • Piling on extra locking hitches. One locking hitch is enough. More just makes a lump that's hard to undo in a hurry.
  • A lock that crosses the wrong way. If the tail doesn't sit parallel to the last diagonal, flip the loop the other way and drop it on again.
  • Too small a cleat. If there isn't room for a turn and a full figure eight, the cleat is undersized for the line. See what size cleat you need.

Releasing it

Lift off the locking hitch, unwind the figure eight, and keep a hand on the turn around the base. Even with the boat pulling, that turn lets you ease the line out under control instead of having it snatched from your hands.

Practice at the slip on a calm day, before you need it in a crosswind. Most people have it down in five tries.

Cleats that suit a cleat hitch

A classic open-base horn cleat with room under the horns is the easiest to tie. These are all 8 inches or longer, which fits typical 3/8 to 1/2-inch dock lines.

Next guide: Stainless vs. aluminum vs. galvanized vs. nylon dock cleats