Adding a cleat to a boat is a common upgrade: a midship cleat for spring lines, a stern cleat for a dinghy, or a pair of pull-up cleats for a cleaner deck. The job is simple, but boat decks are less forgiving than dock boards, so a few details matter.
1. Choose the spot
- Pick a place where the line will lead cleanly to the dock without crossing sharp edges, through a chock or fairlead if needed.
- Check underneath first. You need to reach the underside to fit nuts and a backing plate, and you need to avoid wiring, fuel lines and hull-to-deck joints.
- Keep it clear of walkways, or choose a pull-up or pop-up cleat that sits flush.
2. Choose the cleat
Match the size to your dock lines (see dock line basics) and match the material to the boat's other hardware. On most boats that means 316 stainless, which handles salt water and won't mix metals with existing fittings.
3. Protect the deck core
Many fiberglass decks have a core of balsa or foam sandwiched between fiberglass skins. If water reaches the core through a bolt hole, it rots or delaminates. The usual fix:
- Drill each hole oversize.
- Dig out a little core around the hole, then fill it with thickened epoxy.
- Once cured, drill the correct-size hole through the solid epoxy plug.
Now the bolt passes through solid epoxy instead of core, and water can't get in.
4. Back it up
Fit a backing plate under the deck: stainless, aluminum or G-10, noticeably bigger than the cleat base. Without one, a hard pull can crack the fiberglass around the cleat. More in cleat backing plates.
5. Bed and tighten
Bed the cleat and bolts in a marine sealant made for deck hardware, add the backing plate, washers and lock nuts, and tighten evenly until the sealant just squeezes out. Some people tighten partway, let the sealant cure, then snug them down so a gasket of sealant stays under the base.
Common mistakes
- Drilling straight into a cored deck without sealing the core
- Skipping the backing plate
- Using self-tapping screws instead of through-bolts
- Mounting where the line chafes on the rub rail or gelcoat
Boat cleats in the database
- Accon Marine Pop-Up Cleat 6in6" · 5/8" line · 316 stainless steel
- Accon Marine Pop-Up Cleat with Rod Holder 6in6" · 1/2" line · 316 stainless steel
- Sea-Dog Stainless Steel Open Base Cleat 6in6" · ~3/8" line · 316 stainless steel
- Whitecap Stainless Hollow Base Cleat 6in6" · ~3/8" line · 316 stainless steel
- Sea-Dog Stainless Steel Open Base Cleat 8in8" · ~1/2" line · 316 stainless steel
- Whitecap Stainless Hollow Base Cleat 8in8" · ~1/2" line · 316 stainless steel
Next guide: Anatomy of a dock cleat: every part, labeled
