- 316 stainless
- A marine grade of stainless steel that resists salt water better than 304.
- Backing plate
- A plate or block under the deck or dock that spreads a cleat's load across a larger area. See backing plates.
- Bitt
- A sturdy vertical post on a boat or dock for securing lines, often in pairs.
- Bollard
- A short, thick post on a dock or pier used for mooring larger vessels. Lines are dropped over it with a loop.
- Bow line
- The dock line from the front of the boat to the dock.
- Breast line
- A line run straight across from the boat to the dock to hold the boat in close.
- Chafe guard
- A sleeve or wrap that protects a line where it rubs on an edge, chock or piling.
- Chock
- A fitting on the edge of a boat that guides a line from a cleat over the side.
- Cleat
- A fitting with two horns for securing a line. See the anatomy of a cleat.
- Cleat hitch
- The standard knot for tying a line to a horn cleat. See how to tie one.
- Clove hitch
- A quick knot for tying around a piling or post. It can slip, so it's often finished with half hitches.
- Cored deck
- A boat deck with a core of balsa or foam between fiberglass skins. Holes must be sealed so water can't reach the core.
- Eye splice
- A permanent loop woven into the end of a line.
- Fairlead
- A fitting that guides a line in the right direction to reduce chafe.
- Fender
- A cushion hung between a boat and a dock or another boat.
- Finger pier
- A narrow dock that runs alongside a boat slip.
- Galvanic corrosion
- Faster corrosion that happens when two different metals touch in salt water, such as stainless bolts in an aluminum cleat.
- Galvanized
- Iron or steel coated with zinc to slow rust. The coating wears over time.
- Horn cleat
- The classic cleat shape with two horns. Most dock and deck cleats are horn cleats.
- Investment cast
- A precise casting method that produces smooth, solid parts. Common for stainless boat cleats.
- Lag screw
- A heavy wood screw. Easy to install, but much weaker than a through-bolt for cleats.
- Max line size
- The largest diameter line a manufacturer says a cleat can take.
- Piling
- A post driven into the bottom that supports a dock or marks a slip.
- Pop-up cleat
- A spring-assisted cleat that sits flush and pops up when pressed.
- Pull-up cleat
- A recessed cleat you lift up to use and push back down after.
- Slip
- The water space where a boat is kept at a dock.
- Spring line
- A line led forward or aft from the middle of the boat that stops it surging along the dock.
- Stern line
- The dock line from the back of the boat to the dock.
- Stud mount
- A cleat with threaded rods built into its base, installed from below with nuts. No bolt heads show on top.
- Through-bolt
- A bolt that passes all the way through the deck or dock and is secured with a nut underneath. The strongest way to mount a cleat.
- Windage
- How much of a boat's surface catches the wind. High windage means more load on lines and cleats.
Missing a term? Let us know.
Next guide: Dock cleat size calculator
